2.3. Booting the machine

First, configure the terminal program, in our case minicom, the following way: 9600 bps, 8 bits, no parity, 1 stop bit and no flow control of any kind. The serial port in Linux should be /dev/ttyS0 for COM1, /dev/ttyS1 for COM2 etc.

Start the target. You should see the vxWorks bootloader on your terminal screen, and should be able to stop the boot sequence by pressing the space bar.

Once the target is stopped, run the VisionICE software and perform the following steps:

• Initialize the target by pressing Target|Initialize

• Press File|Load Executable. A dialog box will open, asking you to choose a file. Please choose your kernel image (vmlinux). Before pressing Load, don't forget to enter a value in the +/- Bias field.

  The bias field makes it possible to tell ICE to load a certain image in a different address than what's stated in the ELF binary. We wanted to load the kernel into address 0x300000, and since the binary was linked to 0xC0000000, we entered -0xBFD00000.

• Once the image is loaded succesfully, you can press Run or Step to start executing your kernel.

After pressing the Run button, nothing happened. At that moment, and for some time after, it seemed that nothing was happening and the kernel was stuck. We used ICE to step through the initialization code of the kernel and rule out some potential problems, like virtual memory errors, only to finally discover that the problem was simple: the kernel was indeed booting but since the console (tty) driver had problems, we couldn't see anything!