Log in as root from the serial console and send the console into single user mode. The modem may hang up whilst doing this and you may need to re-connect.
Without a /etc/ioctl.save containing the saved terminal settings, init assumes a directly attached terminal running at 9600bps with 8 data bits, no parity, 1 stop bit and no flow control. Configure your terminal with these settings.
remote.example.edu.au ttyS0 login: root Password: … sh# rm -f /etc/ioctl.save bash# telinit 1 …Telling INIT to go to single user mode. INIT: Going single user INIT: Sending processes the TERM signal sh# stty sane -parenb cs8 crtscts brkint -istrip -ixoff -ixon |
As you use stty to alter the Linux's terminal settings remember to also alter the settings of the attached terminal.
Exiting from single user mode back to the default run level will save the serial console termnial configuration into /etc/ioctl.save.
The terminal settings saved in /etc/ioctl.save will be used if the machine boots into single user mode for any reason.
If your attached terminal or modem cannot alter speed to 9600bps then the above procedure cannot be followed. ioctlsave has been written for this special case. It saves the current terminal settings to a file in the same format as ioctl.save. The procedure is shown in Figure 8-1.